How To Operate A Power Inverter

ACSOON ANDW48 series sine wave inverter, Input voltage is 48VDC, and the output is AC 220V AC. Mainly for power plants, power systems, chemical industry, and other important occasions to provide uninterrupted power. Compared with conventional uninterruptible Power Supply (UPS), inverter power supply has the following advantages in power plants

Install and operation

The upper terminals are:

"+": positive pole of DC input, "-": negative pole of DC input, pay attention to positive and negative pole and do not connect them reversely;

"L": live line of bypass input, "n": zero line of bypass input, "GND": ground line of AC output;

"L": live line of AC output, "n": zero line of AC output, "GND": ground line of AC output.

When unpacking, please check whether the box is damaged. If the box is obviously deformed, please immediately

Contact the supplier.

1. Confirm that the start switch on the front panel is in the "stop" position. The DC air switch on the back of the chassis is also in the "stop" position.

2. Please connect the DC line to the terminal correctly according to the input mark in the inverter, and do not connect "+" - "reversely!

3. Start up: first connect the DC input of the power supply, set the DC air switch at the back of the chassis to the "start" position, then set the start switch on the front panel of the power supply to the "start" position, and the "inverter" indicator light of the power supply will be on, indicating that the inverter works normally. The voltmeter and ammeter start to display the working status at this time.

4. Shutdown: set the start switch on the front panel of the power supply to the "stop" position, and then set the DC air switch behind the power supply to the "stop" position, and the power supply stops working